D-Link DXS-3600-16S Manual page 201

12-5 debug output
This command is used to set a specified module's debug message output to the debug buffer or local console.
debug output {module <MODULE_LIST> | all} {buffer | console | terminal}
Parameters
module
MODULE_LIST
all
buffer
console
terminal
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#debug output all buffer
DXS-3600-32S(config)#
12-6 show error-log
This command is used to show error log information.
show error-log
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the module to output debug messages.
Specifies the module list.
Specifies all the modules to output debug messages.
Specifies the module's debug message output to debug buffer.
Specifies the module's debug message output to local console.
Specifies the module's debug message output to the current session.
The default debug output is buffer.
Global Configuration Mode.
Level: 15
Use the command to set a specified module's debug message output to debug to the
buffer or local console. If the user uses the command in a Telnet session, the error
message will also output to the local console.
This example shows how to configure all modules to debug message outputs to the
debug buffer.
None.
None.
EXEC Mode.
Level: 15
The user can use the show error-log command to display the current error log.
193