D-Link DXS-3600-16S Manual page 657

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/2
DXS-3600-32S(config-if)#switchport mode dot1q-tunnel
DXS-3600-32S(config-if)#switchport vlan mapping 1-10 dot1q-tunnel 200
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/3
DXS-3600-32S(config-if)#switchport mode trunk
DXS-3600-32S(config-if)#switchport vlan mapping 10 original-inner-vlan 20 100
DXS-3600-32S(config-if)#
71-4 inner-priority-trust
This command is used to set the trusting Dot1Q priority. Use no command to remove the setting.
inner-priority-trust
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport mode dot1q-tunnel
DXS-3600-32S(config-if)#inner-priority-trust
DXS-3600-32S(config-if)#
71-5 insert-dot1q-tag
This command is used to specify the Dot1Q VLAN tag inserting. Use the no command to remove the Dot1Q VLAN tag
inserted.
insert-dot1q-tag VLAN-ID
Parameters
VLAN-ID
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to set selective QinQ on port 2. C-VLANs 1-10 are mapped
to S-VLAN 200.
This example shows how to set 2:1 VLAN translation on trunk port 3. This rule
translates the outer VLAN 10 to 100 for the packet which has the original outer VLAN
10 and inner VLAN 20.
None.
No trust dot1q priority set.
Interface Configuration Mode.
Level: 12
This command is available for on physical ports or link aggregation groups that are
set to 802.1Q tunnel mode.
When trusting the Dot1Q priority on a Dot1Q tunnel port, the priority of the Dot1Q
VLAN tag in the received packets will be copied to service VLAN tag. If no trust value
is set, the priority of the service VLAN tag will be assigned according to the default
priority of the reception port.
This example shows how to set the interface port 1 to trust Dot1Q priority.
Specifies the Dot1Q VLAN ID that is inserted to the untagged packets which are
received on the Dot1Q tunnel port.
649