Internet Group Management Protocol (Igmp) Commands - D-Link DXS-3600-16S Manual

Internet Group Management Protocol (IGMP)
Commands
23-1 clear ip igmp group
This command is used to clear dynamic group member information obtained from the response messages in the IGMP
buffer.
clear ip igmp group [group-address | interface ifname]
Parameters
group-address
ifname
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#clear ip igmp group
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#clear ip igmp group 224.0.255.1
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#clear ip igmp group interface vlan2
DXS-3600-32S(config)#
23-2 ip igmp static-group
This command is used to directly add an interface to a group. You can use this command to add an interface to a
group. Use the no form of this command to remove the setting.
ip igmp static-group group-address
no ip igmp static-group group-address
Parameters
group-address
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the address of the multicast group. This is a multicast IP address in four-
part dotted-decimal notation.
Specifies the interface name.
None.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
The IGMP buffer includes a list that contains the dynamic multicast groups that the
hosts in the direct subnet join. If the device joins a group, this group will be included
in this list. To delete all the dynamic group entries from the IGMP buffer, use the
clear ip igmp group command without parameters.
This example shows how to clear all entries from the IGMP cache.
This example shows how to clear entries for the multicast group 224.0.255.1 from
the IGMP cache.
This example shows how to clear the IGMP-group cache entries from a specific
interface of the IGMP-group cache.
Specifies the address of the multicast group. This is a multicast IP address in four-
part dotted-decimal notation.
257