Show Mpls Ldp Discovery - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show mpls ldp interface
Interface: if1
---------------------------------------
Admin State
Oper State
Targeted Hello Accept : Acceptable
Hello Interval
Hello Hold Time
Distribution Method
Interface: if2
--------------------------------------
Admin State
Oper State
Targeted Hello Accept : Acceptable
Hello Interval
Hello Hold Time
Distribution Method
Total Entries: 2
DXS-3600-32S#
38-33 show mpls ldp targeted-peer
This command is used to display previously configured targeted peer information.
show mpls ldp targeted-peer [IP-ADDRESS]
Parameters
IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mpls ldp targeted-peer
Targeted Peer Hello Interval
------------- --------------
192.10.1.1 15(Sec)
192.10.1.2 15(Sec)
Total Entries: 2
DXS-3600-32S#

38-34 show mpls ldp discovery

This command is used to display LDP peer information.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display LDP interface information.
: Enabled
: Disabled
: 5(Sec)
: 15(Sec)
: DoD
: Enabled
: Disabled
: 5(Sec)
: 15(Sec)
: DoD
(Optional) Specifies the targeted peer's IP address that will display. If not specified,
all targeted peer information will be displayed.
None.
EXEC Mode.
Level: 3.
This command is used to display previously configured targeted peer information.
This example shows how to display previously configured targeted peer information.
Hold Time
-----------
45(Sec)
45(Sec)
363