D-Link DXS-3600-16S Manual page 529

Parameters
1
2
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config-router)#version 2
DXS-3600-32S(config-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config)#address-family ipv4 vrf VPN-A
DXS-3600-32S(config-router-af)#version 2
52-17 address-family ipv4 vrf (RIP)
This command is used to create an RIP VRF instance and enter the RIP VRF address family configuration mode. Use
the no form of this command to remove the RIP VRF instance.
address-family ipv4 vrf vrf-name
no address-family ipv4 vrf vrf-name
Parameters
vrf vrf-name
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies RIP Version 1.
Specifies RIP Version 2.
By default RIPv1 packets are sent out and both RIPv1 and RIPv2 packets are
received.
Router Configuration Mode.
Router Address Family Configuration Mode.
Level: 8. (EI Mode Only Command)
This command defines the default RIP version. This version will be override if
version is explicitly specified for the interface (e.g. interface command ip rip receive
version).
Please note when receiving and sending packets are all be disabled or both version
is Version 1, the configuration of authentication will be cleared.
You can verify your settings by entering the show ip rip interface command.
This example shows how to configure the global RIP version to Version 2.
This example shows how to configure RIP global version to version 2 in VRF VPN-A.
Specifies the name of the VRF.
By default, no RIP VRF instance is created.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
This command is used to configure RIP routing instances that use IPv4 address
prefixes. After executing this command, the address faimly configuration mode will
be entered and a new RIP VRF routing instance will be created with this command. If
the no form of this command is executed, the related configurations of the RIP VRF
instance will be removed.
You can verify your settings by entering the show ip rip vrf command.
521