D-Link DXS-3600-16S Manual page 655

71-2 frame-tag tpid
This command is used to specify the outer TPID associated with a NNI port.
frame-tag tpid TPID
no frame-tag tpid
Parameters
TPID
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport mode trunk
DXS-3600-32S(config-if)#frame-tag tpid 0x88a8
DXS-3600-32S(config-if)#
71-3 switchport vlan mapping
This command is used to specify the VLAN translation or selective QinQ rule. Use no command to remove the rule.
switchport vlan mapping ORIGINAL-VLAN [,|-] {[original-inner-vlan VLAN-ID] TRANSLATED-VLAN | dot1q-
tunnel VLAN-ID} [priority COS-VALUE] [inner-vlan VLAN-ID]
no switchport vlan mapping ORIGINAL-VLAN [,|-] [ORIGINAL-INNER-VLAN]
Parameters
ORIGINAL-VLAN
original-inner-vlan VLAN-
ID
TRANSLATED-VLAN
dot1q-tunnel VLAN-ID
priority COS-VALUE
inner-vlan VLAN-ID
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the TPID for the outer VLAN tag. The value is in hexadecimal form. Range
is 0x0 to 0xFFFF.
The default value is 0x8100.
Interface Configuration Mode.
Level: 12
This command is available for physical ports or link aggregation groups that are set
to trunk mode only.
This setting is only effective for trunk port that is used as service provider NNI port.
When packets are egress from NNI port, its TPID in the service VLAN tag will be set
according the configuration.
Setting port to no trunk mode leads to its outer TPID reset to default value.
This example shows how to set the TPID of interface port 1 to 0x88A8.
Specifies the original VLAN ID that will be matched for incoming packets. The range
is 1-4094.
(Optional) Specifies the original inner VLAN ID that will be matched for incoming
packets. The range is 1-4094.
Specifies the translated service VLAN ID. The range is 1-4094. The service VLAN
will replace the original VLAN for matched packets.
Specifies the service VLAN ID that will be added for matched packets.
(Optional) Specifies the priority for the rule. If no specified, the priority of the service
VLAN tag will be set according the default priority of the reception port.
(Optional) Specifies the new inner VLAN that will replace original inner VLAN.
No VLAN mapping rule is configured.
647