Show Lsp Trigger - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls label protocol ldp
DXS-3600-32S(config-mpls-router)#lsp trigger 10 permit ip 192.1.1.0/24
DXS-3600-32S(config-mpls-router)#lsp trigger 20 deny any
DXS-3600-32S(config-mpls-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls label protocol ldp
DXS-3600-32S(config-mpls-router)#no lsp trigger
DXS-3600-32S(config-mpls-router)#

38-43 show lsp trigger

This command is used to display LSP trigger filter rule(s).
show lsp trigger [SN]
Parameters
SN
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show lsp trigger
SN Prefix FEC
----- --------------
10 192.1.1.0/24
20 Any
Total Entries : 2
DXS-3600-32S#
38-44 mpls qos policy
This command is used to enter the MPLS QoS configuration mode. If the policy doesn't exist, a new policy will be
created. Use the no mpls qos policy command to remove the policy.
mpls qos policy <NAME>
no mpls qos policy [all | <NAME>]
Parameters
NAME
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to create an LSP trigger filter rule that permits the
establishment LSP for 192.1.1.0/24 and do not permit the establishment LSP for
other routes.
This example shows how to clear all LSP trigger filter rules.
(Optional) Specifies the sequence number of the LSP trigger filter rule that will be
displayed. If not specified, all rules will be displayed.
None.
EXEC Mode.
Level: 3.
Use this command to display LSP trigger filter rule(s).
This example shows how to display all LSP trigger filter rules.
Action
--------
Permit
Deny
Specifies the MPLS QoS policy name. The maximum name length is 32.
371