D-Link DXS-3600-16S Manual page 319

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lldp message-tx-hold-multiplier 3
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no lldp message-tx-hold-multiplier
DXS-3600-32S(config)#
32-5 lldp tx-delay
This command is used to set the minimum time (delay-interval), any LLDP port will delay advertising successive LLDP
advertisements due to a change in LLDP MIB content. The tx-delay defines the minimum interval between sending of
LLDP messages due to constantly change of MIB content. Use the no form of this command to return to the default
settings.
lldp tx-delay seconds
no lldp tx-delay
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lldp tx-delay 8
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no lldp tx-delay
DXS-3600-32S(config)#
32-6 lldp reinit-delay
This command is used to set the minimum time of the re-initialization delay interval on the switch. Use the no form of
this command to return to the default settings.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This parameter is a multiplier on the msgTxInterval that used to compute the TTL
value of txTTL in an LLDPDU. The TTL will be carried in the LLDPDU packet.
The lifetime will be the minimum of 65535 and (message_tx_interval *
message_tx_hold_multiplier). At the partner switch, when the TTL for a given
advertisement expires, the advertised data is deleted from the neighbor switch's
MIB.
This example shows how to set the LLDP message-tx-hold-multiplier to 3.
This example shows how to set the LLDP message-tx-hold-multiplier to the default
value.
Specifies a delay for sending successive LLDPDU on an interface. Valid values are
from 1 to 8192 seconds.
2 seconds.
Global Configuration Mode.
Level: 12
The LLDP message TX interval (transmit interval) must be greater than or equal to 4
times the TX delay interval).
This example shows how to set the TX delay interval to 8 seconds.
This example shows how to configure the TX delay interval to default value.
311