D-Link DXS-3600-16S Manual page 637

PE2:
DXS-3600-32S(config)#interface vlan 20
DXS-3600-32S(config-if)#mpls ip
DXS-3600-32S(config-if)#mpls label protocol ldp
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#mpls ip
DXS-3600-32S(config)#mpls label protocol ldp
DXS-3600-32S(config-mpls-router)#ldp router-id 130.1.1.2
DXS-3600-32S(config-mpls-router)#exit
DXS-3600-32S(config)#interface GigabitEthernet 1/0/1
DXS-3600-32S(config-if)#encapsulation dot1q 10
DXS-3600-32S(config-subif)#xconnect 2 110.1.1.1 encapsulation mpls
68-2 show mpls l2transport vc
This command is used to display the VPWS VC information.
show mpls l2transport vc [VC-ID] [detail]
Parameters
VC-ID
detail
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mpls l2transport vc
VC ID Peer
---------- -------------- -------------------- ------
1 150.1.1.4
2 130.1.1.2
3 140.1.1.2
4 160.1.1.2
Total Entries: 4
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to display the specified PW ID only.
Specifies to display detailed PW information.
None.
EXEC Mode.
Level: 3.
None.
This example is used to display information of all VCs.
Local AC
Eth1/0/1/VLAN2
Eth1/0/1/VLAN3
Eth1/0/1/VLAN4
Eth1/0/1/VLAN4
Type Oper Status
-----------
Raw Up
Tagged Down
Tagged Up
Tagged Standby
629