D-Link DXS-3600-16S Manual page 363

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls label protocol ldp
DXS-3600-32S(config-mpls-router)#mpls ldp lsp-control-mode ordered
38-21 mpls ldp distribution-mode
This command is used to set the label distribution mode for the interface. Use the no form of this command to restore
the default value.
mpls ldp distribution-mode {dod | du}
no mpls ldp distribution-mode
Parameters
dod
du
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 10
DXS-3600-32S(config-if)# mpls ldp distribution-mode du
38-22 loop-detection
This command is used to enable loop detection. Use the no form of this command to disable loop detection.
loop-detection
no loop-detection
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the LSP control mode to ordered.
Specifies to use the downstream on-demand distribution mode.
Specifies to use the downstream unsolicited mode.
Downstream Unsolicited Distribution Mode.
Interface Configuration Mode.
Level: 12.
This command only can be applied on Layer 3 VLAN interface. This command is
used to configure the label distribution method. If the label distribution method is
Downstream-on-Demand, the downstream LSR advertises a label mapping when an
upstream connection makes an explicit request.
If the method is Downstream-Unsolicited, it allows a LSR distributes label bindings to
LSRs that have not explicitly requested them.
Note: If LDP is running, configuring label distribution method will lead to LDP
sessions restart.
This example shows how to configure the label distribution mode to Downstream
Unsolicited for VLAN 10 interface.
None.
Disabled.
MPLS Router Configuration Mode.
Level: 15.
355