D-Link DXS-3600-16S Manual page 170

Parameters
receive
send
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip bgp packet receive
DXS-3600-32S#
BGP:Peer:<10.1.1.10> RCV OPEN, version:<4>,remote-as:<40>, HoldTime:<180>,RID:<16.0.0.1>
BGP:Peer:<10.1.1.10> RCV KEEPALIVE.
BGP:Peer:<10.1.1.10> RCV UPDATE, withdraw: <21.0.0.0/8>,<22.0.0.0/8>,<23.0.0.0/8>, <24.0.0.0/
8>,<25.0.0.0/8>...
BGP:Peer:<10.1.1.10> RCV UPDATE,attr:<Orign:i,As-path:10,Next-hop:10.1.1.10,Med:5>, NLRI:
<21.0.0.0/8>,<22.0.0.0/8>
BGP:Peer:<10.1.1.10> RCV NOTIFYCATION,Code:<OPEN Message Error.>,SubCode:<Bad Peer AS.>
BGP:Peer:<10.1.1.10> RCV REFRESH,afi:<1>,safi:<1>
BGP:Peer:<10.1.1.10> RCV Capability Action:Set,Code: GRST ,Length:2
7-98 debug ip bgp route-map
This command is used to turn on BGP route map debug switch. Use the no form of this command to turn off BGP route
map debug switch.
debug ip bgp route-map
no debug ip bgp route-map
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip bgp route-map
DXS-3600-32S#
Route-Map:<rmap-1>, Apply Suppressed Route, Neighbor <100.1.1.4, AFI/SAFI 1/1>,
Prefix:<67.1.1.0/24> <Permit>
Route-Map:<rmap-2>, Apply Received route, Neighbor <100.1.1.2, AFI/SAFI 1/1>,Prefix: <88.1.1.0/
24> <Deny>
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to turn on BGP received packet debug switch.
Specifies to turn on BGP sent packet debug switch.
By default BGP packet debug switch is turned off.
Privileged Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on BGP packet debug switch. When BGP protocol
packets are received or transmitted, debug information will be print if BGP debug
function is turned on.
Use the command debug ip bgp to turn on BGP debug function.
This example shows how to turn on BGP received packet debug switch.
None.
By default BGP route map debug switch is turned off.
Privileged Mode.
Level: 15. (EI Mode Only Command)
Use this command to turn on BGP route map debug switch. When route map is
matching BGP route information, debug information will be print if BGP debug
function is turned on.
Use the command debug ip bgp to turn on BGP debug function.
This example shows how to turn on BGP route map debug switch.
162