D-Link DXS-3600-16S Manual page 621

Example
DXS-3600-32S#show vlan mac-base
MAC Address
------------------
00-80-CC-00-00-11
Total Entries: 1
DXS-3600-32S#
Example
DXS-3600-32S#show vlan subnet-base
Subnet
------------------------
20.0.0.0/8
192.0.0.0/8
3FFE:22:33:44::/64
Total Entries: 3
DXS-3600-32S#
66-13 protocol-vlan profile
This command is used to create a protocol group. Use the no protocol-vlan profile command to remove the specified
protocol group.
protocol-vlan profile PROFILE-ID frame-type {ethernet2 | snap | llc} ether-type TYPE-VALUE
no protocol-vlan profile PROFILE-ID
Parameters
PROFILE-ID
frame-type
ethernet2
snap
llc
ether-type TYPE-VALUE
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example displays the MAC-based VLAN table: The MAC-based VLAN can be
set by manual configuration or by MAC-based authorization. If the authorization
assigns the MAC address that is set by manual configuration to different VLAN, the
manual configuration MAC-based VLAN entry becomes inactive.
VLAN ID Priority
-------- --------
101 4
This example displays the subnet-based VLAN table.
VLAN ID Priority
------- ---------
100 0
100 4
100 0
Specifies the profile ID to add or delete.
Specifies the frame type that will be bound to the entry.
Specifies the operational protocol value of Ethernet II type frames.
Specifies the operational protocol value of SNAP type frames.
Specifies the operational protocol value of LLC type frames.
Specifies the protocol value of the specific frame type. The value is in hexadecimal
form. The range is 0x0 to 0xFFFF.
By default, the protocol VLAN table is empty.
Global Configuration Mode.
Level: 12
The protocol-vlan profile configuration command can be used to create a protocol
group.
The no protocol-vlan profile command can be used to delete an existing protocol
VLAN group.
Status
----------
Active
613