D-Link DXS-3600-16S Manual page 458

Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip pim query-interval 60
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 2
DXS-3600-32S(config-if)#no ip pim query-interval
DXS-3600-32S(config-if)#
47-3 ip pim join-prune-interval
This command is used to configure the interval of Protocol Independent Multicast (PIM) router join/prune messages. To
return default, use the no form of this command.
ip pim join-prune-interval SECONDS
no ip pim join-prune-interval
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The change of hello interval would lead to the change of hello hold time. The
principle of the updating hold time is configured hello interval * 3.5.
To verify your configuration, use show ip pim dense-mode interface detail or
show ip pim sparse-mode interface detail.
This example shows how to configure the PIM query interval of VLAN 1 to 60
seconds.
This example shows how to configure the query interval of VLAN 2 back to default.
Specifies the interval to send the join/prune message, in the range 1 to 18724
seconds.
60 seconds.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
This command only takes effect when the interface is PIM-SM enabled.
When configuring the Join/Prune interval, the user needs to consider the factors,
such as configured bandwidth and expected average number of multicast route
entries for the attached network or link (For example, the period would be longer for
lower-speed links, or for routers in the center of the network that expect to have a
larger number of entries).
For SM-mode, router will periodically send the join message based on this interval.
The hold-time in a Join/Prune message is (3.5 * join-prune-interval). The receiving
router will start a timer based on this hold-time, and prune the interface if hold-time
timer expires.
You can verify your configuration through command show ip pim sparse-mode
interface detail.
450