Debug Ip Bgp Show Network - D-Link DXS-3600-16S Manual

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip bgp show peer-group
BGP Peer Group :local1
-----------------------------------------------------------------------
Session State
Session Activity
Members
Remote AS
Holdtime Interval
Keepalive Interval
Advertisement Interval
AS Origination Interval
Connect Retry Interval
EBGP Multihop
Weight
Next Hop Self
Remove Private AS
Allowas In
Route Reflector Client
Soft Reconfiguration Inbound
Community Sent to this Neighbor
Default Originate
Incoming Update Prefix List
Incoming Update Filter List
Route Map for Outgoing Routes
Unsuppress Map
Capability ORF Prefix List
Pass Word
Prefix Max Count
Prefix Warning Threshold
Prefix Max Warning
DXS-3600-32S#

7-103 debug ip bgp show network

This command is used to show internal detailed information about the BGP network.
debug ip bgp show network [vrf VRF-NAME]
Parameters
vrf VRF-NAME
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Privileged Mode.
Level: 15. (EI Mode Only Command)
Use this command to check internal status and detailed information of the BGP peer
group.
This example shows how to display internal detail information about BGP peer
group.
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
None.
Privileged Mode.
Level: 15. (EI Mode Only Command)
Use this command to check internal status and detailed information of the BGP
network.
: Enabled
: Enabled
: 10.2.2.1, 10.2.2.2
: 1
: 180 Seconds
: 60 Seconds
: 5 Seconds
: 0 Seconds
: 0 Seconds
: 1
: 100
: Disabled
: Disabled
: Disabled
: Enabled
: Enabled
: Both Standard and Extended
: Enabled
: prelist1
: ASlist1
: 1
: 2
: None
:
: 16000
: 75
: Disabled
166