D-Link DXS-3600-16S Manual page 658

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport mode dot1q-tunnel
DXS-3600-32S(config-if)#insert-dot1q-tag 10
DXS-3600-32S(config-if)#
71-6 vlan mapping miss drop
This command is used to enable the dropping of VLAN mapping unmatched packets. Use the no command to disable
the VLAN mapping miss dropping action.
vlan mapping miss drop
no vlan mapping miss drop
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport mode dot1q-tunnel
DXS-3600-32S(config-if)#vlan mapping miss drop
DXS-3600-32S(config-if)#
71-7 show dot1q-tunnel
This command is used to display Dot1Q VLAN tunneling configuration on interfaces.
show dot1q-tunnel [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
No Dot1Q VLAN tag inserted.
Interface Configuration Mode.
Level: 12
This command is available for on physical ports or link aggregation groups that are
set to the 802.1Q tunnel mode.
If the insert-dot1q-tag is configured, when the untagged packets are received on
the 802.1Q tunnel port, the specified Dot1Q VLAN tag will be inserted into it.
This example shows how to set an interface port 1 to insert inner tag with VLAN 10.
None.
VLAN mapping miss dropping is disabled.
Interface Configuration Mode.
Level: 12
This command is available for on physical ports or link aggregation groups that are
set to the 802.1Q tunnel mode.
If the VLAN mapping miss dropping option is enabled on the reception port, when
the original VLAN of the received packets cannot match the VLAN mapping rules on
this port, the received packets will be dropped.
This example shows how to set interface port 1 to enable the VLAN mapping miss
dropping option.
(Optional) Specifies the interfaces that will be displayed. If not specified, display all
802.1Q tunnel ports.
650