D-Link DXS-3600-16S Manual page 477

48-4 mls qos cos
This command is used to define the default class of service (CoS) value of a port. Use the no form of this command to
return to the default setting.
mls qos cos default-cos
no mls qos cos
Parameters
default-cos
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#mls qos cos 4
DXS-3600-32S(config-if)#
48-5 mls qos map dscp-cos
This command is used to define a differentiated services code point (DSCP) to class of service (CoS) map in global
configuration mode. To restore to the default setting, use the no form of this command.
mls qos map dscp-cos dscp-list to cos
no mls qos map dscp-cos
Parameters
dscp-list
cos
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to assign a default CoS value to a port. If packets are untagged, the default
CoS value becomes the packet CoS value. The CoS range is 0 to 7.
The default CoS value is 0.
Interface Configuration Mode.
Level: 15
Only physical ports are valid for this command.
Use mls qos cos command to specify the default CoS of the port. The CoS of the
packets will be the packet's CoS if the packets are tagged, and will be the port
default CoS if the packet is untagged.
This example shows how to set the default CoS to 4 for interface tenGigabitEthernet
1/0/1.
Specifies the list of DSCP to be mapped to a COS value. The range of DSCP is 0 to
63. The series of DSCPs can be separated by comma (,) or hyphen (-) with no
spaces or hyphen - before and after.
Specifies the associated CoS value.
DSCP -> CoS:
0..7 => 1
8..15 => 2
16..23 => 0
24..31 => 3
32..40 => 4
41..47 => 5
48..55 => 6
56..63 => 7
Global Configuration Mode.
Level: 15
469