D-Link DXS-3600-16S Manual page 571

57-11 spanning-tree mst
This command is used to set the path cost and port-priority parameters for any MST instance (including the CIST with
instance ID 0). To return to the default settings, use the no form of this command.
spanning-tree mst INSTANCE-ID {cost COST | port-priority PRIORITY}
no spanning-tree mst INSTANCE-ID {cost | port-priority}
Parameters
INSTANCE-ID
cost COST
port-priority PRIORITY
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree mst 0 cost 32
Success
DXS-3600-32S(config-if)#
57-12 spanning-tree mst priority
This command is used to configure the bridge priority value for the selected MSTP instance. Use the no form of this
command to return the setting to default setting.
spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Parameters
INSTANCE-ID
PRIORITY
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the MSTP instance identifier. The instance 0 represents for default
instance, CIST.
(Optional) Specifies the internal path cost for an instance. Valid values are from 0 to
200000000 and 0 means auto.
(Optional) Specifies the port priority for an instance. Valid values are from 0 to 240 in
increments of 16.
The default port priority is 128.
Interface Configuration Mode.
Level: 8
Higher cost values indicate higher costs.
Smaller port-priority priority values indicate higher priorities.
This example shows how to set the internal path cost of instance 0.
Specifies the MSTP instance identifier. The instance 0 represents for default
instance, CIST.
Specifies the bridge priority value must be divisible by 4096. The range is 0 to 61440.
The default value is 32768.
Global Configuration Mode.
Level: 8
This command is used to configure the bridge priority for special MST instance.
563