D-Link DXS-3600-16S Manual page 341

lldp-med tlv-select {inventory-management | location | network-policy | power-management | capabilities}
no lldp-med tlv-select {inventory-management | location | network-policy | power-management |
capabilities}
Parameters
inventory-management
location
network-policy
power-management
capabilities
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp-med tlv-select inventory-management
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp-med tlv-select capabilities
DXS-3600-32S(config-if)#
34-4 show lldp-med
This command is used to display the switch's global LLDP-MED configuration status.
show lldp-med
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This TLV type indicates that the LLDP agent should transmit 'LLDP-MED inventory
TLV'.
This TLV type indicates that the LLDP agent should transmit 'LLDP-MED location
policy TLV'.
This TLV type indicates that the LLDP agent should transmit 'LLDP-MED network
policy TLV'.
This TLV type indicates that the LLDP agent should transmit 'LLDP-MED extended
Power via MDI TLV' if local device is PSE device or PD device.
This TLV type indicates that the LLDP agent should transmit 'LLDP-MED capabilities
TLV'. If user wants to transmit LLDP-MED PDU, this TLV type should be enabled.
Otherwise, the interface cannot transmit LLDP-MED PDU
No LLDP-MED TLV is selected.
Interface Configuration Mode.
Level: 12
This command is used to enable or disable transmit LLDP-MED TLVs.
Setting non-supported capability shall have no functional effect and will result in an
inconsistent value error returned to the management application.
It's effectively disables LLDP-MED on a per-port basis by disabling transmission of
capabilities TLV. In this case the remote table's objects in the LLDP-MED MIB
corresponding to the respective port will not be populated.
This example shows how to set LLDP MED inventory TLVs.
This example shows how to enable LLDP-MED to transmit LLDP-MEDPDU.
None.
None.
User EXEC Mode.
Level: 3
This command displays the switch's general LLDP-MED configuration status.
333