D-Link DXS-3600-16S Manual page 522

52-10 network
This command is used to enable RIP on one interface. Use the no form of this command to restore to the default
setting.
network network-number
no network
Parameters
network-number
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config-router)#network 10.0.0.0
DXS-3600-32S(config-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# router rip
DXS-3600-32S(config)# address-faimly ipv4 vrf VPN-A
DXS-3600-32S(config-router-af)# network 100.1.1.0
52-11 redistribute (RIP)
This command is used to redistribute routes from another routing domain into the RIP domain. Use no form of the
command to remove route redistribution settings to RIP.
redistribute {connected | static | bgp |ospf} [metric value] [route-map map_name]
no redistribute {connected | static | bgp |ospf} [metric value] [route-map map_name]
Parameters
connected
static
bgp
ospf
metric value
route-map map_name
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the IP address of the network of directly connected networks. The interface
whose IP address belongs to the network can transmit and receive the RIP packets.
By default, RIP is disabled on all interfaces.
Router Configuration Mode.
Router Address Family Configuration Mode.
Level: 8. (EI Mode Only Command)
You can verify your settings by entering the show ip rip command.
This example shows how to enable RIP on the interface 'vlan1' (10.0.0.0/8).
This example shows how to enable RIP on interface ip100 associated to VRF VPN-A
(100.1.1.1/24).
(Optional) Specifies that the connected routes are to be redistributed into RIP
domain.
(Optional) Specifies that the static routes are to be redistributed into RIP domain.
(Optional) Specifies that the BGP routes are to be redistributed into RIP domain.
(Optional) Specifies that the OSPF routes are to be redistributed into RIP domain.
(Optional) Specifies that the RIP route metric value for the redistributed routes. The
value range is 0 to 16.
(Optional) Specifies the route map that should be interrogated to filter the importation
of routes from this source routing protocol to the RIP protocol. If not specified, all
routes are redistributed.
514