Secure Shell (Ssh) Commands - D-Link DXS-3600-16S Manual

Secure Shell (SSH) Commands

54-1 ip ssh time-out
This command is used to specify the time interval that the switch waits for the SSH client to respond. Use the no form
of this command to reset the time interval that the switch waits for the SSH client to respond.
ip ssh time-out <sec 30-600>
no ip ssh time-out
Parameters
time-out <sec 30-600>
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip ssh time-out 240
DXS-3600-32S(config)#
54-2 ip ssh authentication-retries
This command is used to specify the number of authentication attempts after which the session is reset or
authentication failed. Use the no form of this command to reset the number of authentication attempts after which the
session is reset or authentication failed.
ip ssh authentication-retries <int 2-20>
no ip ssh authentication-retries
Parameters
authentication-retries <int
2-20>
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the time interval that the switch waits for the SSH client to respond. The
range is 30 to 600 seconds and this parameter is only applied to the negotiation
phase.
The default time out value for the switch waiting for the SSH client to respond is 120
seconds.
Global Configuration Mode.
Level: 8
This parameter is only applied to the negotiation phase. If the negotiation phase has
not completed during the time specified by this parameter, the connection be
disconnected directly.
After the execution shell starts, the CLI-based timers will start.
Note: The modification of CLI-based timers or other CLI-based parameters can not
be applied the connected SSH sessions, i.e. the modification of CLI-based
parameters can only be applied to the SSH sessions after those modifications.
This example shows how to specify the SSH time interval value to 240 seconds.
Specifies the number of times that a client can reauthenticate. The range is 2 to 20
times.
The default authentication retry time is 3.
Global Configuration Mode.
Level: 8
If authentication fails, the SSH connection attempted will be disconnected if the total
number of failed times has exceeded the value specified by this command.
536