Line Commands - D-Link DXS-3600-16S Manual

LINE Commands

30-1 line
This command is used to enter the specified LINE mode. The no form of this command is used to restore the default
configuration.
line {console | telnet | ssh}
no line {console | telnet | ssh}
Parameters
console
telnet
ssh
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#
30-2 exec-timeout
This command is used to configure the connection timeout to this equipment in the LINE, use the exec-timeout
command. Once the connection timeout in the LINE is cancelled by the no exec-timeout command, the connection will
never be timeout.
exec-timeout minutes [seconds]
no exec-timeout
Parameters
minutes
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#exec-timeout 5 30
DXS-3600-32S(config-line)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the console port.
Specifies the Telnet terminal line.
Specifies the SSH terminal line.
None.
Global Configuration Mode.
Level: 15
Access to the specified LINE mode.
This example shows how to enter the LINE mode from LINE CONSOLE.
Specifies the minutes of specified timeout. This value must be between 0 and 1439.
(Optional) Specifies the seconds of specified timeout.
The default timeout is 10min.
Line Configuration Mode.
Level: 15
If there is no input/output information for this connection within specified time, this
connection will be interrupted, and this LINE will be restored to the free status.
This example shows how to specify the connection timeout is 5'30".
301