D-Link DXS-3600-16S Manual page 181

Example
DXS-3600-32S#show network-access guest-vlan
VID : 1
Member Ports: 1/0/4
VID : 3
Member Ports: 1/0/1, 1/0/8
Total Entries: 2
DXS-3600-32S#
Display Parameters
VID
Member Ports
8-3 network-access authentication-mode
This command is used to configure the authentication mode for the network-access authentication module. Use the no
form of this command to return to the default setting.
network-access authentication-mode {port-based | host-based}
no network-access authentication-mode
Parameters
port-based
host-based
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#network-access authentication-mode port-based
DXS-3600-32S(config-if)#
8-4 show network-access auth-configure
This command is used to display the authentication configuration settings.
show network-access auth-configure [interface <interface-id>]
Parameters
interface <interface-id>
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows the output from the show network-access guest-vlan in
EXEC command.
Description
The guest VLAN VID.
The guest VLAN member ports.
Specifies that if one of the attached hosts passes the authentication, all hosts on the
same port will be granted access to the network. If the user fails to authenticate, this
port will keep trying the next authentication
Specifies that every user can be authenticated individually.
Authentication mode is host-based.
Interface Configuration Mode.
Level: 8
Use the show network-access auth-configure command to show the interface
configuration for network-access authentication mode.
This example shows how to configure interface 1 to port-based mode.
Dispays the configured information settings for the specified interface.
173