Match Extcommunity; Match Interface - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S(config)#ip community-list standard A-COMMUNITY permit 101:1
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#match community A-COMMUNITY exact
DXS-3600-32S(config-route-map)#

53-4 match extcommunity

This command is used to add a match command to match a Border Gateway Protocol (BGP) extended community
(extcommunity) list. Use the no form of this command to delete the match command with BGP extended community
list.
match extcommunity EXTCOMMUNITY-LIST-NAME
no match extcommunity
Parameters
EXTCOMMUNITY-LIST-
NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# ip extcommunity-list standard EXTCOM permit rt 192.168.1.1:100
DXS-3600-32S(config)# route-map rmap1 permit 10
DXS-3600-32S(config-route-map)# match extcommunity EXTCOM
DXS-3600-32S(config-route-map)#

53-5 match interface

This command is used to add a match command to match the outgoing interface of routes. Use the no form of this
command to delete the match command with outgoing interface of routes.
match interface ipif_name
no match interface
Parameters
ipif_name
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to add a match command to match a BGP community list.
Specifies the name of the BGP extended community list. The length is up to 16
characters.
None.
Route Map Configuration Mode.
Level: 8. (EI Mode Only Command)
The BGP extended community list is created with the command ip extcommunity-list.
Only one community list is supported. If this command is executed with a different
community list, the old one will be overwritten. You can verify your settings by
entering the show route-map command.
This example is used to add a match command to match a BGP extended
community list.
Specifies the name of the outgoing interface of routes.
None.
Route Map Configuration Mode.
Level: 8
525