Lldp Transmit; Lldp Receive - D-Link DXS-3600-16S Manual

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/2
DXS-3600-32S(config-if-range)#lldp management-address ipv4 10.1.1.1
DXS-3600-32S(config-if-range)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/2
DXS-3600-32S(config-if-range)#no lldp management-address ipv4 10.1.1.1
DXS-3600-32S(config-if-range)#

32-10 lldp transmit

This command is used to enable the LLDP advertise (transmit) capability. Use the no form of this command to return to
the default settings.
lldp transmit
no lldp transmit
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp transmit
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no lldp transmit
DXS-3600-32S(config-if)#

32-11 lldp receive

This command is used to enable the LLDP receive capability. Use the no form of this command to return to the default
settings.
lldp receive
no lldp receive
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command specifies whether the system's IP address needs to be advertised
from the specified port.
For Layer 3 devices, each managed address can individually be specified.
The management addresses that are added in the list will be advertised in the LLDP
from the specified interface, associated with each management address. The
interface for that management address will be also advertised in the if-index form.
This example shows how to enable ports 1 to 2 for setting the management address
entry (IPv4).
This example shows how to delete the management address entry (IPv4) from ports
1 to 2.
None.
LLDP is enabled on all supported interfaces.
Interface Configuration Mode.
Level: 12
None.
This example shows how to enable the transmit state.
This example shows how to disable the transmit state.
314