D-Link DXS-3600-16S Manual page 643

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#vrrp 7 priority 200
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no vrrp 7 priority
DXS-3600-32S(config-if)#
69-6 vrrp timers advertise
This command is used to configure the interval between successive VRRP advertisements by the master router. Use
the no form of this command to restore to the default value.
vrrp vrid timers advertise interval
no vrrp vrid timers advertise
Parameters
vrid
interval
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The master of a virtual router is elected based on the priority setting. The router that
owns the virtual router IP address has the highest priority to be elected.
The router with the highest priority will become the master, and other routers with a
lower priority will then act as the backup for the virtual router. Each router should be
configured with different priority values. If there are multiple routers with the same
highest priority value, the router with the highest numbers in its IP address will
become the master. The router that is the IP address owner of the VRRP group is
always the master of the VRRP group.
Use the command show vrrp to verify your settings.
This example shows how to configure the priority of VRRP group 7 to be 200 on
interface vlan1.
This example shows how to reset the priority of VRRP group 7 to the default value
on interface vlan1.
Specifies the virtual router identifier. The valid range is from 1 to 255.
Specifies the time interval between successive advertisements by the master router.
The unit of the interval is second. The valid value is from 1 to 255.
The default value of advertisement interval is 1 second.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The maser will constantly send the VRRP advertisements to communicate the
related information of the current master virtual router. The vrrp timers advertise
command configures the interval between advertisement packets and the time
before other routers declare the master router as down. All routers in a VRRP group
must use the same timer values.
Use the command show vrrp to verify your settings.
635