D-Link DXS-3600-16S Manual page 32

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#mac access-list extended 6001
DXS-3600-32S(config-mac-nacl)#end
DXS-3600-32S#show access-list
Extended IP access list 3999 ext_ipv6
10 permit ip any any
Extended MAC access list 6001 ext-mac-6001
DXS-3600-32S#
3-8 permit | deny (mac access-list)
Use the permit command to add a permit entry. Use the deny command to add a deny entry. Use the no command to
remove an entry.
[sn] {permit | deny} {source-mac-address mask | host source-mac-address | any} {destination-mac-address mask
| host destination-mac-address | any} [ethernet-type] [cos out [inner in]]
no sn
Parameters
sn
source-mac-address
destination-mac-address
mask
any
ethernet-type
cos out
inner in
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Extended MAC ACL only filters the Non-IP packet. The name must be unique among
all (including MAC, IP, IPv6 or Expert) access-lists and the first character of name
must be a letter.
When creating an ACL through the assignment of a name, an ID will be assigned
automatically. The ID assignment rule will start from the maximum ID of 7999 and
decrease by 1 for envery new ACL created.
When creating an ACL through the assignment of an ID, a name will be assigned
automatically. The name assignment rule is 'ext-mac' + "-" + ID. If this name conflicts
with the name of an existing ACL, then it will be renamed based on the following rule:
'ext-mac' + "-" + ID +"alt".
This example shows how to create an extended MAC ACL.
(Optional) Specifies the ACE sequence number. This number must be between 1
and 65535.
Specifies the source MAC address.
Specifies the destination MAC address.
Specifies the MAC address mask.
Means any source or destination MAC address.
(Optional) Specifies the Ethernet type as a pair of hexadecimal numbers and the
mask (from 0x0 to 0xFFFF) or the name of the Ethernet type. Names that can be
used are 'arp', 'aarp', 'appletalk', 'decnet-iv', 'etype-6000', 'etype-8042', 'lat', 'lavc-
sca', 'mop-console', 'mop-dump', 'vines-echo', 'vines-ip', 'xns-idp'.
Specifies the out priority value used. This value must be between 0 and 7.
(Optional) Specifies the inner priority value used. This value must be between 0 and
7.
None.
Extended MAC Access-list Configuration Mode.
Level: 12
A sequence number will be assigned automatically if the user did not assign it
manually. Automatic assignment of sequence numbers will start from 10 and
increase by 10 for every new entry created.
24