D-Link DXS-3600-16S Manual page 380

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

all
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#mpls qos policy policy1
DXS-3600-32S(config-mpls-qos)#
38-45 trust-exp
This command is used to configure to trust the incoming label's topmost EXP as priority. Use the no trust-exp
command to disable the trust.
trust-exp
no trust-exp
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S#(config)#mpls qos policy policy1
DXS-3600-32S#(config-mpls-qos)#trust-exp
DXS-3600-32S#(config-mpls-qos)#
38-46 class-map
This command is used to configure class mapping of the policy. Use the no class-map command to remove the
setting.
class-map {inbound exp <VALUELIST 0-7> priority <VALUE 0-7> | outbound [priority <VALUELIST 0-7>] exp
<VALUE 0-7>}
no class-map {inbound | outbound}
Parameters
exp <VALUELIST 0-7>
priority <VALUE 0-7>
priority <VALUELIST 0-7> (Optional) Specifies the priorities that will be mapped to the outbound EXP. If not
exp <VALUE 0-7>
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to remove all MPLS QoS policies.
No MPLS QoS policy.
Global Configuration Mode.
Level: 8.
Use this command to enter the MPLS QoS configuration mode. If the policy doesn't
exist, a new policy will be created. The MPLS QoS policy can be applied to MPLS
FECs.
This example shows how to create an MPLS QoS policy with the name of policy1.
None.
Disabled.
MPLS QoS Configuration Mode.
Level: 15.
Use this command, in the MPLS QoS configuration mode, to configure to trust the
incoming label's topmost EXP as priority. If the EXP is set to trust, the matched
packets are scheduled according to the EXP to priority map the MPLS QoS policy.
Otherwise, the packets are scheduled according to the 802.1p priority.
This example shows how to enable EXP trust.
Specifies the EXP or EXP range.
Specifies the priority of the inbound EXP mapped.
specifies, then all priorities will be mapped.
Specifies the outbound EXP.
372

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents