Switchport Mode - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1000-1005
DXS-3600-32S(config-vlan)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no vlan 1000-1005
DXS-3600-32S(config)#
66-2 name
This command is used to specify the name of a VLAN. Use the no name command to reset the VLAN name to the
default VLAN name.
name VLAN-NAME
no name
Parameters
VLAN-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1000
DXS-3600-32S(config-vlan)#name admin-vlan
DXS-3600-32S(config-vlan)#

66-3 switchport mode

This command is used to specify the VLAN mode for the port. Use no switchport command to reset the VLAN mode
to default setting.
switchport mode {access | hybrid | trunk | dot1q-tunnel}
no switchport mode
Parameters
access
hybrid
trunk
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
In the following example, the user adds a new VLAN, assigning the new VLAN with
the VLAN IDs 1000 to 1005.
In the following example, the user removes the existing VLANs with the VLAN IDs.
Specifies the VLAN name. This name is an ASCII string from 1 to 32 characters that
must be unique within the administrative domain. The syntax is a general string that
does not allow spaces.
The default VLAN name is VLANxxxx, where xxxx represents four numeric digits
(including the leading zeros) that are equal to the VLAN ID.
VLAN Configuration Mode.
Level: 12
The user can use the name VLAN-NAME VLAN configuration command to specify a
VLAN name. The VLAN name length must be between 1 and32 characters, and it
must be unique within the administrative domain.
In the following example, the user configures the VLAN name of VLAN 1000 to be
"admin-vlan".
Specifies the port as an access port.
Specifies the port as a hybrid port.
Specifies the port as a trunk port.
604