D-Link DXS-3600-16S Manual page 408

Usage Guideline
Example
DXS-3600-32S#show ip ospf area
OSPF Area Settings
Area ID Type
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None
0.0.0.1 NSSA
0.0.0.2 Stub
DXS-3600-32S#
Display Parameters
Area ID
Type
Stub Import Summary LSA
Stub Default Cost
Translate
Example
DXS-3600-32S#show ip ospf area 0.0.0.0
Area ID: 0.0.0.0
SPF algorithm runs for area 0.0.0.0: 0 time
Number of LSA in this area: 0
Number of ABR in this area: 0
DXS-3600-32S#
Display Parameters
Area ID
Area Type
SPF algorithm runs for area
Number of LSA in this area
Checksum Sum
Number of ABR in this area
Number of ASBR in this area The count of AS boundary router in this area.
Example
DXS-3600-32S#show ip ospf area vrf VPN-A
OSPF Area Settings (VRF : VPN-A)
Area ID Type
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command is used to show OSPF areas information. When the area ID is
specified, the detail information about this area will be displayed.
This example shows how to check OSPF area settings.
Stub Import Summary LSA Stub Default Cost Translate
Disabled
Disabled
Description
Identifier of area. ID 0.0.0.0 is backbone area.
Type of area. It could be normal, stub or NSSA.
Whether to prohibit summary routes advertised into the area. It is only for stub or
NSSA area. It is specified with the command area stub or area nssa.
The cost for the default summary route used for a stub or NSSA area. It is specified
with the command area default-cost.
Whether on NSSA area leak the type-7 LSA outside to other areas. It is only for
NSSA area and specified with the command area nssa.
This example shows how to check OSPF areas 0.0.0.0 detail information.
Area Type: Normal
Checksum Sum: 0x0
Number of ASBR in this area: 0
Description
Identifier of area. ID 0.0.0.0 is backbone area.
Type of area. It could be normal, stub or NSSA. It is specified with the command
area, area stub and area nssa.
The times of SPF calculation in this area.
The count of LSAs in this area.
The sum of checksum for all LSAs in this area.
The count of area border router in this area.
This example show how to check the OSPF areas settings in the VRF VPN-A:
Stub Import Summary LSA Stub Default Cost Translate
None None
1 Disabled
1 None
None None
400