D-Link DXS-3600-16S Manual page 154

Display Parameters
Accepted Prefixes
Last read
Send Statistics
Opens (send)
Notifications (send)
Updates (send)
Keepalives (send)
Route Refresh (send)
Total (send)
Receive Statistics
Opens (receive)
Notifications (receive)
Updates (receive)
Keepalives (receive)
Route Refresh (receive)
Total (receive)
Connections Established
Connections Dropped
Local Host
Local Port
Remote Host
Remote Port
Due Time for Next Start
Timer
Due Time for Next Connect
Timer
7-83 show ip bgp network
This command is used to display networks created by Border Gateway Protocol network command.
show ip bgp network [vrf VRF-NAME] [NETWORK-ADDRESS]
Parameters
vrf VRF-NAME
NETWORK-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
Number of routes accepted by the local BGP. These routes are contained in the Loc-
RIB.
Time that BGP last received a message from this neighbor. Format is HH:MM:SS.
The statistics information of the outgoing packets.
Number of OPEN packets sent to the neighbor.
Number of NOTIFICATIONS packets sent to the neighbor.
Number of UPDATES packets sent to the neighbor.
Number of KEEPALIVES packets sent to the neighbor.
Number of ROUTEREFRESH packets sent to the neighbor.
Total packets sent to the neighbor.
The statistics information of the incoming packets.
Number of OPEN packets received from the neighbor.
Number of NOTIFICATIONS packets received from the neighbor.
Number of UPDATES packets received from the neighbor.
Number of KEEPALIVES packets received from the neighbor.
Number of ROUTEREFRESH packets received from the neighbor.
Total packets received from the neighbor.
Number of times that the local BGP establish the TCP connection with the neighbor.
Number of times that the TCP connection been dropped.
IP address of the local BGP.
TCP port of the local BGP.
IP address of the neighbor.
TCP port of the neighbor.
BGP peer auto re-start timer value next time. Seconds.
BGP peer re-connect timer value next time when peer session connect fail.
Seconds.
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
Specifies the IP network address. If a specific network address is not specified, all IP
addresses will be displayed.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
This command displays the networks advertised by BGP.
146