Ospf Area Aggregation Settings - D-Link xstack DES-3810 series Reference Manual

Layer 3 managed ethernet switch
Hide thumbs Also See for xstack DES-3810 series:
Table of Contents

Advertisement

®
xStack
Dead Interval (1-65535)
Authentication
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.
After clicking the Edit button, the following page with be displayed.
The fields that can be configured are described below:
Parameter
Hello Interval (1-65535)
Dead Interval (1-65535)
Authentication
Click the Apply button to accept the changes made.
Click on the <<Back button to return to the previous window.

OSPF Area Aggregation Settings

This window is used to configure the OSPF area aggregation settings.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPF Area Aggregation Settings, as shown
below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Allows the specification of the length of time between the receipts of Hello packets from a
neighbor router before the selected area declares that router down. The Dead Interval
must be evenly divisible by the Hello Interval.
Select the authentication used. Options to choose from are None, Simple and MD5. When
choosing Simple authentication, a Password must be entered. When choosing MD5
authentication, a Key ID must be entered.
Figure 6-40 OSPF Virtual Link Settings – Edit window
Description
Allows the specification of the interval between the transmissions of OSPF Hello packets,
in seconds. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key
should be the same for all routers on the same network.
Allows the specification of the length of time between the receipts of Hello packets from a
neighbor router before the selected area declares that router down. The Dead Interval
must be evenly divisible by the Hello Interval.
Select the authentication used. Options to choose from are None, Simple and MD5. When
choosing Simple authentication, a Password must be entered. When choosing MD5
authentication, a Key ID must be entered.
Figure 6-41 OSPF Area Aggregation Settings window
197

Advertisement

Table of Contents
loading

Table of Contents