Lsp Trigger - D-Link DXS-3600-16S Manual

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

Example
DXS-3600-32S#traceroute lsp 192.1.1.0/24
Tracing route to 192.1.1.0/24
1 Reply from 170.1.1, time<10ms
2 Reply from 200.1.2.3, time=20ms
3 Reply from 210.1.1.4, time=30ms
4 Reply from 192.1.1.1, time=40ms
Trace complete.
DXS-3600-32S#
Example
DXS-3600-32S#traceroute lsp 110.1.1.0/24
Tracing route to 110.1.1.0/24
1 Reply from 170.1.1, time<10ms
2 Request time out
Trace complete.
DXS-3600-32S#

38-42 lsp trigger

This command is used to configure an LSP trigger filter rule. Use the no form of this command to remove the rule.
lsp trigger [SN] {permit | deny} {ip NETWORK-PREFIX/PREFIX-LENGTH | any}
no lsp trigger [SN [- | ,]]
Parameters
SN
permit
deny
ip NETWORK-PREFIX/
PREFIX-LENGTH
any
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to trace route the LSP for network 192.1.1.0/24.
This example shows how to trace route the LSP for network 110.1.1.0/24.
(Optional) Specifies the sequence number of the LSP trigger filter rule. When
creating a new rule and the SN option is not specified, the SN value will begin from
10 and will then be incremented by 10. When removing a rule and the SN option is
not specified, all rules will be removed. The SN range is 1-10000.
Specifies to permit LDP establishing LSP for the following IP prefix FEC.
Specifies not to permit LDP establishing LSP for the following IP prefix FEC.
Specifies the IP prefix FEC for the rule.
Specifies that the rule will be applied to any IP prefix FEC.
No LSP trigger filter rule.
MPLS Router Configuration Mode.
Level: 15.
This command is used to configure an LSP trigger filter rule. The LSP trigger filter
rules are IP access list rules that it is used to control the IP routes that can be used
to trigger the establishment of an LSP. For example, if there are two routes for
172.18.1.0/24 and 172.18.2.0/24 and if the LSP trigger filter permits 172.18.1.0/24
and denies 172.18.2.0/24, then the switch can only establish an LSP for 172.18.1.0/
24.
370

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents