D-Link DXS-3600-16S Manual page 397

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip ospf cost 2
DXS-3600-32S(config-if)#
40-15 ip ospf dead-interval
This command is used to configure the interval during which at least one hello packet form a neighbor must be
received before it is declared dead. Use the no command to restore it to the default value.
ip ospf dead-interval seconds
no ip ospf dead-interval
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip ospf dead-interval 60
DXS-3600-32S(config-if)#
40-16 ip ospf hello-interval
This command is used to configure the interval between hello packets. Use the no command to restore it to the default
value.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The default value is 1
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The interface cost reflects the overhead for sending the packet across the interface.
This cost is advertised as the link cost in the router link advertisement. The cost is
inversely proportional to the speed of an interface. The cost can be either manually
assigned or be automatically determined.
Users can verify the settings by entering the show ip ospf interface command.
This example shows how to set System interface's OSPF interface cost to 2,
Specifies the interval in seconds. The value range is 1 to 65535.
The default interval is 40 seconds.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The dead-interval is the amount of time that the router waits to receive an OSPF
hello packet from the neighbor before declaring the neighbor down. This value is
advertised in the router's hello packets. It must be the same for all routers on a
specific network.
Please note that the dead-interval can not be less than the hello-interval and must be
multiple times as hello-interval.
Users can verify the settings by entering the show ip ospf interface command.
This example shows how to set the dead-interval of System interface (VLAN 1) to 60
seconds.
389