Multiprotocol Label Switching (Mpls) Commands - D-Link DXS-3600-16S Manual

Multiprotocol Label Switching (MPLS) Commands

38-1 mpls ip (global configuration)
This command is used to enable the MPLS forward globally. Use no mpls ip command in global configuration mode to
disable MPLS forward globally.
mpls ip
no mpls ip
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls ip
DXS-3600-32S(config)#
38-2 snmp-server enable traps mpls lsp
This command is used to enable MPLS LSP trap state. Use the no form of this command to disable MPLS LSP trap
state.
snmp-server enable traps mpls lsp
no snmp-server enable traps mpls lsp
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server enable traps mpls lsp
DXS-3600-32S(config)#
38-3 mpls ip (interface configuration)
This command is used to enable the MPLS forward on this interface. Use the no mpls ip command in interface
configuration mode to disable the MPLS forward on this interface.
mpls ip
no mpls ip
Parameters
Default
Command Mode
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Disabled.
Global Configuration Mode.
Level: 3.
This command enables MPLS function in the global level.
This example shows how to enable MPLS globally.
None.
Disabled.
Global Configuration Mode.
Level: 3.
This command used to configure the MPLS LSP trap state. If the state is enabled, a
trap is sent out when a LSP's operation status changes to up or down.
This example shows how to enable MPLS LSP trap state.
None.
Disabled.
Interface Configuration Mode.
344