D-Link DXS-3600-16S Manual page 184

Example
DXS-3600-32S#show bootup-config
#-------------------------------------------------------------------------------
#
#
#
#
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# DEVICE
configure terminal
logging-server enable device
end
# PRIVMGMT
configure terminal
# COMMAND LEVEL START
# COMMAND LEVEL END
9-3 execute flash:
This command is used to execute the configuration of device, stored in the NVRAM, by using the increment method.
execute flash: FILENAME
Parameters
FILENAME
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows the boot-up configuration information stored in the NVRAM.
The field descriptions are self-explanatory.
DXS-3600-32S TenGigabit Ethernet Switch
Configuration
Firmware: Build 1.10.023
<The Output is Truncated>
Specifies the name of the configuration file, stored in the NVRAM.
None.
Privileged Mode.
Level: 15
The command is used to execute the configuration by using the increment method.
This means that the new configuration will merge with the current configuration. The
existing configuration will not be cleared before applying of the new configuration.
To verify the executed result, use the show running-config command.
Note: The configuration file name and contents can be specified. Once edited, users
send the configuration file to the FLASH of the network device in TFTP. The contents
of the configuration file will simulate the input completely. Hence, it is necessary to
edit the contents of the configuration file by the sequence that CLI commands are
configured. Furthermore, for some interactive commands, it is necessary to write
corresponding response information in the batch file, guaranteeing that the
commands can be executed normally.
176