D-Link DXS-3600-16S Manual page 314

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/2
DXS-3600-32S(config-if-range)#port-group mode active
DXS-3600-32S(config-if-range)#
31-7 show aggregateport
This command is used to display the aggregate port configurations.
show aggregateport {aggregate-port-number summary | load-balance}
Parameters
aggregate-port-number
summary
load-balance
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show aggregateport 1 summary
AggregatePort MaxPorts
------------- --------
Ag1 12
DXS-3600-32S#
Example
DXS-3600-32S#show aggregateport load-balance
Link Aggregation Algorithm : src-mac
DXS-3600-32S#
31-8 show lacp summary
This command is used to show the LACP aggregation information.
show lacp summary
Parameters
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
By default, the aggregation mode is passive on the interface.
Interface Configuration Mode.
Level: 15
None.
This example shows how to configure Ethernet interface 1-2 to active mode.
Specifies the number of the aggregate port.
Displays information of the designated aggregate port.
Displays the global load balance.
None.
EXEC Mode.
Level: 15
None.
This example shows information of aggregate port 1.
SwitchPort Mode Ports
--------------- -----
ACCESS 1-4
This example shows the algorithm of aggregate port 1.
None.
306