D-Link DXS-3600-16S Manual page 49

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#arp timeout 120
DXS-3600-32S(config)#
Example
DXS-3600-32S(config)#no arp timeout
DXS-3600-32S(config)#
4-3 clear arp cache
This command is used to remove one or all dynamic ARP entries from the ARP cache table.
clear arp-cache [vrf <string 1-12>] [ip-address] [interface interface-name]
Parameters
vrf
ip-address
interface interface-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#clear arp-cache
DXS-3600-32S#
Example
DXS-3600-32S#clear arp-cache 1.1.1.1
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The default timeout value is 20 minutes.
Global Configuration Mode.
Level: 8
The ARP timeout setting is only applicable to the IP address and the MAC address
mapping that are learned dynamically. The shorter the timeout, the truer the mapping
table saved in the ARP cache, but the more network bandwidth occupied by the
ARP. Hence the advantages and disadvantages should be weighted. Generally it is
not necessary to configure the ARP timeout too shorter unless there is a special
requirement.
Users can verify the settings by entering the show arp timeout command.
This example shows how to tonfigure the timeout value, for the dynamic ARP
mapping record, to 120 minutes.
This example shows how to restore the timeout value, for the dynamic ARP mapping
record, to 20 minutes.
Specifies the VRF that the IP reside in. If no VRF name is specified, the global
instance will be used.
(Optional) Enter the IP address of the dynamic ARP entry here.
(Optional) Specifies the interface from which the dynamic ARP entry was learned.
None.
Privileged Mode.
Level: 8
This command can be used to clear the dynamic ARP entries.
Use the show ip arp command to view the current state of the ARP cache table.
This example shows how to remove all dynamic ARP entries.
This example shows how to remove a dynamic ARP entry with the IP address
1.1.1.1
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents