Show Interface Loopback - D-Link DXS-3600-16S Manual

no shutdown
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface out-band 1
DXS-3600-32S(config-if)#shutdown
DXS-3600-32S(config-if)#
25-4 show interface out-band
This command is used to display the out band interface.
show interface out-band <int>
Parameters
int
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show interface out-band 1
Interface
Interface Admin State : Enabled
IPv4 Address
Gateway
Link Status
DXS-3600-32S#

25-5 show interface loopback

This command is used to display all the IP interfaces.
show interface loopback <int>
Parameters
int
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, the interface is enabled.
Interface Configuration Mode.
Level: 8
This command is used to disable or enable an interface.
Users can verify the settings by entering the show interface out-band command.
This example shows how to shutdown the out-band interface 1.
Specifies the out-band interface number.
None.
EXEC Mode.
Level: 3
Use this command to display the out-band interface.
This example shows how to display the out-band interface 1.
: out-band1
: 10.1.1.1/8
: 0.0.0.0
: Link Down
Specifies the loopback interface number.
282