D-Link DXS-3600-16S Manual page 137

Example
DXS-3600-32S#show ip bgp community vrf 100 50:2
BGP Local Router ID is 11.11.11.11
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
IP Address/Netmask
Route Distinguisher: 1:100 (default for VRF 100)
*> 56.1.1.0/24
*> 56.1.2.0/24
*> 56.1.3.0/24
DXS-3600-32S#
Display Parameters
BGP Local Router ID
Status codes
Origin codes
IP Address/Netmask
Gateway
Metric
LocPrf
Weight
Path
7-75 show ip bgp community-list
This command is used to display routes that are permitted by the Border Gateway Protocol (BGP) community list.
show ip bgp community-list [{all | rd ASN:NN | vrf VRF-NAME}] COMMUNITY-LIST-NAME [exact-match]
Parameters
all
rd ASN:NN
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The following example displays routes with the community 50:2 in VRF 100:
Gateway
50.1.1.10
50.1.1.10
50.1.1.10
Description
The router identifier of the local BGP router.
Status of the table entry displayed at the beginning of each line. It can be one or
more of the following values:
s - The table entry is suppressed.
d - The table entry is damped.
h - The table entry is damped and has been withdrawn by the neighbor.
* - The table entry is valid.
> - The table entry is the best entry to use for that network.
i - The table entry was learned via an internal BGP (iBGP) session.
Origin of the table entry displayed at the end of each line. It can be one of the
following values:
i - Entry originated from an Interior Gateway Protocol (IGP) and was advertised
with a network router configuration command.
e - Entry originated from an Exterior Gateway Protocol (EGP).
? - Origin of the path is not clear. Usually, this is a router that is redistributed into
BGP from an IGP.
IP prefix with its mask length of the entry.
IP address of the next router that is used when forwarding a packet to the destination
network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to
this network.
If shown, this is the value of the inter-autonomous system metric. This field is
frequently not used.
Local preference value as set with the set local-preference route-map configuration
command. The default value is 100.
Weight of the route as set via autonomous system filters.
Autonomous system paths to the destination network.
(Optional) Specifies to display routes of all VPN and VRFs.
(Optional) Specifies to display routes with the specified Route Distinguisher. The
ASN:NN can be IP address:number or AS number:number.
Metric LocPrf
0 0
0 0
0 0
129
Weight Path
10 i
10 i
10 i