D-Link DXS-3600-16S Manual page 312

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lacp port-priority 4096
DXS-3600-32S(config-if)#
31-3 lacp system-priority
This command is used to set the LACP system priority. The no form of it restores it to the default.
lacp system-priority system-priority
no lacp system-priority
Parameters
system-priority
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lacp system-priority 4096
DXS-3600-32S(config)#
31-4 lacp timeout
This command is used to configure the LACP timeout mode. Use the no form of this command to return to the default
value.
lacp timeout {short | long}
no lacp timeout
Parameters
short
long
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure port priority of Ethernet interface 1.
Specifies the LACP system priority, in the range of 0-65535.
By default, the system priority is 32768.
Global Configuration Mode.
Level: 15
The LACP system priority consists of the Layer 2 management MAC address and its
priority value, where the MAC address is fixed but the priority value is configurable. If
two priorities are equal, then the smaller the MAC address is, the higher the priority
is. All LACP groups on the switch share the system priority. Changing the system
priority may influence the whole aggregation groups on the switch.
This example shows how to configure system priority.
Specifies that there will be 3 seconds before the LACP invalidating received
LACPDU information and there will be 1 second between LACP PDU periodic
transmissions when using Short Timeouts.
Specifies that there will be 90 seconds before the LACP invalidating received
LACPDU information and there will be 30 seconds between LACP PDU periodic
transmissions when using Long Timeouts
By default, the LACP timeout mode is short.
Interface Configuration Mode.
Level: 15
304