Set Origin - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map mapmetric permit 10
DXS-3600-32S(config-route-map)#set metric 100
DXS-3600-32S(config-route-map)#
53-17 set metric-type
This command is used to add a set command to modify the metric type of routes. Use the no form of this command to
delete this set command.
set metric-type {type-1 | type-2}
no set metric-type
Parameters
type-1
type-2
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map mapmetrictype permit 10
DXS-3600-32S(config-route-map)#set metric-type type-1
DXS-3600-32S(config-route-map)#

53-18 set origin

This command is used to add a set command to modify the BGP origin code. Use the no form of this command to
delete this set command.
set origin {igp | egp | incomplete}
no set origin
Parameters
igp
egp
incomplete
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to add a set command to modify the metric of routes.
Specifies the OSPF external type 1 metric.
Specifies the OSPF external type 2 metric.
None.
Route Map Configuration Mode.
Level: 8
This command is only applied to the routes redistributed to OSPF.
You can verify your settings by entering the show route-map command.
This example shows how to add a set command to modify the metric type of routes.
Specifies that the origin code of the route will be set to IGP.
Specifies that the origin code of the route will be set to EGP.
Specifies that the origin code of the route will be set to INCOMPLETE.
None.
Route Map Configuration Mode.
Level: 8
533