D-Link DXS-3600-16S Manual page 165

Display Parameters
Ver
AS
MsgRcvd
MsgSent
Up/Down
State/PfxRcd
7-91 show ip community-list
This command is used to display configured community lists.
show ip community-list [COMMUNITY-LIST-NAME]
Parameters
COMMUNITY-LIST-NAME
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
BGP protocol version. And now, value is 4.
The peer's Autonomous system number.
The number of message which receives form this neighbor.
The number of message which be sent to this neighbor.
The length of time that the BGP session has been in the Established state, or the
current status if not in the Established state.
The current state of the BGP session, or the number of prefixes that have been
received from a neighbor or peer group. When the maximum number (as set by the
neighbor maximum-prefix command) is reached, the string "PfxRcd" appears in
the entry, the neighbor is shut down, and the connection is set to Idle. An (Admin)
entry with Idle status indicates that the connection has been shut down using the
neighbor shutdown command.
Specifies the community list name. The maximum length is 16 characters.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
This command can be used without any arguments or keywords. If no arguments are
specified, this command will display all community lists. However, the community list
name can be specified when entering the show ip community-list command. This
option can be useful for filtering the output of this command and verifying a single
named community list.
157