Loopback Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Client State
Click the Apply button to accept the changes made.
The fields that can be configured for DHCPv6 Client PD Settings are described below:
Parameter
Client PD State
General Prefix Name
Click the Apply button to accept the changes made.

Loopback Interface

This window is used to view and configure the loopback interface settings. A loopback interface is a
software only interface which always stays in the up status.
To view the following window, click L3 Features > Interface > Loopback Interface, as shown below:
The fields that can be configured in Loopback Interface are described below:
Parameter
Interface Loopback
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to modify the specified entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
Description
Select to enable or disable the DHCPv6 client service here. Select the
Rapid Commit option to proceed with two-message exchange for
address delegation. The rapid-commit option will be filled in the Solicit
message to request two messages handshake.
Description
Select to enable or disable the DHCPv6 client process to request the
prefix delegation through a specified interface. Select the Rapid
Commit option to proceed with two-message exchange for prefix
delegation. The rapid-commit option will be filled in the Solicit message
to request two messages handshake.
Enter the IPv6 general prefix name here. This name can be up to 12
characters long.
Figure 6-15 Loopback Interface Window
Description
Enter the loopback interface's ID here. The range is from 1 to 8.
179