Loopback Interface Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Click the <<Back button to return to the previous page.
Click the View Neighbor Discover
Click the <<Back button to return to the previous page.

Loopback Interface Settings

This window is used to configure loopback interfaces. A loopback interface is a logical IP interface which is always
active, until a user disables or deletes it. It is independent of the state of any physical interfaces.
To view this window, click Management > IP Interface > Loopback Interface Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Add button to create a new entry.
Click the Delete All button to remove all the entries listed in the table.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Add or Edit button to see the following window.
Figure 4-12 IPv6 Interface Settings – View All IPv6 Address window
link to see the following window.
Figure 4-13 IPv6 Interface Settings – View Neighbor Discover window
Figure 4-14 Loopback Interface Settings window
Description
Enter an interface name.
64