50
Web User Guide
Example #3: show port interface
Use this command for a specific port. The output shows whether the port is the mirror or the
probe port, what is enabled or disable on the port, etc.
(Console)
Intf
----
0/4
(Console)
Intf
----
0/5
Example #4: show monitor session 1
(Console)
<cr>
(Console)
Session ID
----------
1
Example #5: (Config) monitor session 1 mode
To set up port mirroring, specify the monitor session, then the mode.
(Console)(Config)
session
(Console)(Config)
<1-1>
(Console)(Config)
destination
mode
source
(Console)(Config)
<cr>
(Console)(Config)
Admin
Physical PhysicalLink
Type
Mode
Mode
----
------
-------- --------------
Mirror
Enable
Auto
Admin
Physical PhysicalLink
Type
Mode
Mode
----
------
-------- --------------
Probe
Enable
Auto
Admin Mode
----------
Enable
#show port 0/4
Status
Down
#show port 0/5
Status
Down
#show monitor session 1?
Press Enter to execute the command.
#show monitor session 1
Probe Port
----------
0/5
#monitor?
Configure port mirroring.
#monitor session?
Session number.
#monitor session 1?
Configure the probe interface.
Enable/Disable port mirroring session.
Configure the source interface.
#monitor session 1 mode?
Press Enter to execute the command.
#monitor session 1 mode
Link
LACP
Trap
Mode
----
----
Enable
Enable
Link
LACP
Trap
Mode
----
----
Enable
Enable
Mirrored Port
-------------
0/4