Honda ACCORD HYBRID 2005 Service Manual page 474

Hide thumbs Also See for ACCORD HYBRID 2005:
Table of Contents

Advertisement

Electronic Throttle Control System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
ACAUTION
Do not insert your fingers into the installed throttle
body w h e n y o u turn the ignition switch ON (II) or
w h i l e the ignition switch is ON (II). If y o u do, y o u
w i l l seriously injure your finger if the throttle valve
is activated.
1. Turn the ignition switch ON (II).
2. Clear the DTC w i t h the HDS.
3. Start the engine. Hold the engine speed at
3,000 r p m w i t h o u t load (in Park or neutral) until the
radiator fan comes on, then let it idle.
4. Turn the ignition switch OFF, and wait 10 seconds.
5. Turn the ignition switch ON (II).
6. Check for Temporary DTCs or DTCs w i t h the HDS.
Is DTC P1683
indicated?
Y E S — G o t o step 7.
NO—Intermittent failure, system is OK at this t i m e .
Check for poor connections or loose terminals at
the throttle body and the throttle actuator control
module. •
7. Turn the ignition switch OFF.
8. Disconnect the intake air duct f r o m the throttle
body.
9. Push the throttle valve closed as s h o w n .
NOTE:
• Do not operate the ignition switch during the
check.
• Be careful not to pinch your fingers during the
check.
10. Release the throttle valve.
Does the throttle
valve
return?
Y E S — C l e a n the throttle body (see page 11-381),
then go to step 13.
N O — G o t o step 1 1 .
11. Turn the ignition switch OFF.
12. Replace the throttle body (see page 11-386).
13. Turn the ignition switch O N (II).
14. Reset the PCM w i t h the HDS.
15. Do the PCM idle learn procedure (see page 11-340).
16. Turn the ignition switch OFF, and w a i t 10 seconds.
17. Turn the ignition switch ON (II).
18. Check for T e m p o r a r y DTCs or DTCs w i t h the HDS.
Are any Temporary
DTCs
or DTCs
indicated?
Y E S — I f DTC P1683 is indicated, check for poor
connections or loose terminals at the throttle body
and the throttle actuator control m o d u l e , then go to
step 1. If any other T e m p o r a r y DTCs or DTCs are
indicated, go to the indicated D T C s
troubleshooting.
NO—Troubleshooting is complete. •
11-234

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents