Honda ACCORD HYBRID 2005 Service Manual page 459

P C M R e p l a c e m e n t
1. Connect the HDS to the data link connector (DLC)
(A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Select READ DATA in REPLACE PCM w i t h the HDS.
4. Turn the ignition switch OFF.
5. J u m p the SCS line w i t h the HDS.
6. Remove the center lower covers (A).
7. Remove the duct (B).
8. Disconnect PCM connectors (C).
9. Remove the bolts (D), then remove the PCM (E).
10. Install the PCM in the reverse order of removal.
11. Open the SCS w i t h the HDS.
12. Turn the ignition switch ON (II).
NOTE: DTC P0630 " V I N Not Programmed or
M i s m a t c h " w i l l be stored because VIN has not been
p r o g r a m m e d into the PCM, but ignore it and
continue this procedure.
13. Input the VIN to the PCM w i t h the HDS.
14. Select WRITE DATA in REPLACE PCM w i t h the HDS.
15. Rewrite the immobilizer code w i t h the PCM
replacement procedure in the HDS; it allows you to
start the engine.
16. Reset the PCM w i t h the HDS.
17. Do the PCM idle learn procedure (see page 11-340).
18. Do the CKP pattern learn procedure (see page 11-4).
11-219