Snmp-Server Location - Dell Z9500 Command Reference Manual

Configuring Informs
To send an inform, use the following steps:
1.
2.
3.
4.
5.
Related
snmp-server enable traps
Commands
snmp-server community

snmp-server location

Configure the location of the SNMP server.
Z9500
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Simple Network Management Protocol (SNMP) and Syslog
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the snmp-server community command prior to using this command,
the default form of the snmp-server community command automatically is
configured with the community-name the same as specified in the snmp-
server host command.
Configure a remote engine ID.
Configure a remote user.
Configure a group for this user with access rights.
Enable traps.
Configure a host to receive informs.
— enables SNMP traps.
— configures a new community SNMPv1 or SNMPv2c.
Enter an alpha-numeric text string, up to 55 characters long.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1721