Ip Ospf Hello-Interval - Dell PowerConnect 8024 Cli Reference Manual

seconds — Number of seconds that a router's Hello packets have not been seen before its
•
neighbor routers declare that the router is down. (Range: 1–65535)
Default Configuration
40 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4).
Example
The following example sets the dead interval at 30 seconds.
console(config-if-vlan15)#ip ospf dead-interval 30

ip ospf hello-interval

Use the ip ospf hello-interval command in Interface Configuration mode to set the OSPF hello
interval for the specified interface. Use the no form of the command to return the interval to the
default value.
Syntax
seconds
ip ospf hello-interval
no ip ospf hello-interval
seconds — Number of seconds to wait before sending Hello packets from the interface.
•
(Range: 1–65535)
Default Configuration
10 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The value for the length of time must be the same for all routers attached to a network.
751
OSPF Commands