Priority-Pgid - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

A DCB map is a template used to configure DCB parameters and apply them on

converged Ethernet interfaces. DCB parameters include priority-based flow control

(PFC) and enhanced traffic selection (ETS).

To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map

Use the dcb-map command to create a DCB map to specify PFC and ETS settings

and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC

and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is

enabled on Ethernet ports by default.

The dcb-map command is supported only on physical Ethernet interfaces.

To remove a DCB map from an interface, enter the no dcb-map map-name

command in Interface configuration mode.

priority-pgid

Assign 802.1p priority traffic to a priority group in a DCB map.

priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-

num dot1p3_group-num dot1p4_group-num dot1p5_group-num

dot1p6_group-num dot1p7_group-num

dot1p0_group-

dot1p1_group-

dot1p2_group-

dot1p3_group-

dot1p4_group-

dot1p5_group-

dot1p6_group-

dot1p7_group-

Enter the priority group number for each 802.1p class of

traffic in a DCB map.

Data Center Bridging (DCB)